Based on long-term experience of producing unloading ramps, and constantly communicating with our customers, we would like to highlight several aspects that will help you to use the unloading ramp with maximum efficiency.
Tip one: use the unloading ramp on flat surfaces.
Since all unloading ramps provide a seamless design, it is desirable that the front and rear of the unloading ramp were on flat planes. Imbalances can lead to reduced service life of the ramp.
Tip Two: Do not lower unloading ramp to the minimum level after working with it, if within a short time it will be needed again.
After loading / unloading is complete, ramp is raised and the truck left, you can leave the unloading ramp in an lifted state, if soon will arrive next truck. So you will save a minute or two to set up unloading ramp height to the next job. For long periods of parking (more than an hour), it should be on minimum level without pressure in the hydraulic system of the unloading ramp.
Specialists of company “AV-exim”, manufacturer of mobile ramps AUSBAU, will always be glad to reply on your questions:
Phone +49 302 555 9868
Attention. This article was created by company “AV-exim” and it belongs to company “AV-exim” as intellectual property. It is prohibited to copy partial or full content of this web-site without written confirmation of “AV-exim”.